![]() ![]() If this doesnt work and “Recover” button is still avaible, just fullow these steps ġ – While device is still working, Plug out HDD that you suspect which maybe broken, and press Recover button again. Choose your RAID and press “Recover” to fix. Just go to Disk Managment -> RAID managment. If not, Please dont try anything in this document:ġ – Update your Qnap fimware with Qnapfinder 3.7.2 or higher firmware. If your RAID system seems as the picture down below, fallow this document. Qnap data protection features doesnt let you loose data even if your 5 HDD gives Bad sector errors in 6 HDD RAID Systems. If your system seems In Degraded, Failed Drive X, you probably loose more HDD than RAID tolerated, so Just plug out broken HDD from 2.Th HDD slot, wait around 15 seconds, and Plug in new HDD with the same size. In this case, RAID information seems “RAID 5 Drive 1 3″ so, your 2.th HDD is out of RAID. If not, Please dont try anything in this document: If your RAID system seems as down below, use this document. This document is not valid for Qnap Ts-109 / Ts-209 / Ts-409 & Sub Models. ![]() Dont use new HDDs!Ģ – If you can access your data after these process, backup them quickly.ģ – You can loose data on Hardware RAID devices and other NAS brands, but nearly you cant loose data on Qnap, but recovering your datas may cause time lost, so Always double backup recomended for future cases.Ĥ – If one of your HDD’s cause Qnap to restart itself when you plug in to NAS, Dont use that HDD to solve these kind of cases. ![]() Qnapsupport Taiwan works great to solve this kind of RAID corruptions easly, and My advice is directly contact with them at this kind of cases.ġ – If documetn says “Plug out HDD and Plug in” always use original RAID HDD at the same slot. If you dont know what you’r doing, you may damage your RAID which cause loosing data. Warning : This documents are recomended for Professional users only. VII – IF “config_util 1″ Command gives “Mirror of Root Failed” Eror VI – Stuck at Booting / Starting Sevices, Please Wait / Cant Even Login Qnap Interface V – “Recover” Doesnt Work, How to Fix if RAID Becomes “Unmounted” or “Not Active” IV – How to Fix if RAID Becomes “Unmounted” or “Not Active” III -How to Fix if RAID seems “In Degreed Mode, Read Only, Failed Drive(s) x” Cases II -How to Fix if RAID seems “In Degreed” ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |